Lower Timing Chain Cover, Replacing: Installing

• Replace The Bolts That Were Tightened With An Additional Turn After Removing Them.
• Replace The Lower Timing Chain Cover And Seal After Removal.

-- Cover Any Open Engine Components.

-- Remove Any Sealant Residue On The Cylinder Block Using A Flat Blade Scraper.

-- Clean Any Oil Or Grease Off The Sealing Surfaces.

-- Make Sure Both Alignment Bushings For Centering The Cover -Arrows- Are Present.

Courtesy of AUDI OF AMERICA, LLC

TIP: 

Courtesy of AUDI OF AMERICA, LLC

Be Sure To Check The Expiration Date Of The Sealant.

-- Cut The Tube Nozzle At The Front Marking (Nozzle Diameter: Approximately 3 mm).

Cover With 15 Bolts 

Courtesy of AUDI OF AMERICA, LLC

-- Apply The Sealant As Shown On The Clean Sealing Surface -Arrow 1- And On The Edges -arrows 2- Of The New Cover.

• Sealant Bead Thickness: 2 to 3 mm.
• The Cover Must Be Installed Within Five Minutes After The Sealant Has Been Applied.

-- Immediately attach the cover and tighten the bolts. Refer To Figure.

Cover with Eight Bolts 

Courtesy of AUDI OF AMERICA, LLC

-- Apply The Sealant As Shown On The Clean Sealing Surface -Arrow 1- And On The Edges -Arrows 2- Of The New Cover.

• Sealant Bead Thickness: 2 to 3 mm.
• The Cover Must Be Installed Within Five Minutes After The Sealant Has Been Applied.

-- Immediately Attach The Cover And Tighten The Bolts. Refer To the following figure. .

Continuation 

Courtesy of AUDI OF AMERICA, LLC

• Tighten The Bolts -Arrows- With An Additional Turn After Installing The Vibration Damper. The Bolts Must Be Removed Again To Install The Vibration Damper.
• After Installing The Cover, Allow The Sealant To Harden For Approximately 30 Minutes. Only Afterward May The Engine Oil Be Replenished.

Installation Is Performed In Reverse Order Of Removal, Noting The Following: 

-- Install The Vibration Damper. Refer To VIBRATION DAMPER, REMOVING AND INSTALLING .

-- Non-Hybrid Vehicles: Install The Ribbed Belt Tensioner. Refer To RIBBED BELT TENSIONING DAMPER, REMOVING AND INSTALLING, VEHICLES WITH ELECTRO-MECHANICAL POWER STEERING .

-- Fill The Engine Oil And Check The Oil Level. Refer To ENGINE OIL (CHECK OIL LEVEL) / ENGINE OIL .

There Are Additional Procedures Depending On The Model. Refer To LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING / TIMING CHAIN COVER, REMOVING AND INSTALLING .