LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> A5 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 87 (Cylinder Head, VALVETRAIN (Servicing) [CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB, CHJA, CPEA] (Coupe)) >> 15 Cylinder Head, VALVETRAIN >> Chain Drive >> Bearing Bracket, Removing And Installing >> Removing

Bearing Bracket, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Preliminary Work May Be Required Depending On The Model. Refer To OVERVIEW - CAMSHAFT TIMING CHAINS and OVERVIEW - BALANCE SHAFT DRIVE CHAIN ; Bearing Bracket, Removing and installing. Refer To BEARING BRACKET, REMOVING AND INSTALLING

-- Remove The Upper Timing Chain Cover. Refer To UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .

TIP: 

GWWA15-10767Courtesy of AUDI OF AMERICA, LLC

The Control Valves Have Left-Hand Thread.

-- Depending on the version, remove the control valve in direction of -arrow- using either the :T10352A  or :T10352/1A  .

-- To do so counterhold on the vibration damper with the :T40263  , :T40314  and the 24 mm socket.

GWWA13-11145Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

GWWA15-10444Courtesy of AUDI OF AMERICA, LLC

-- Remove the bearing mount.

-- Remove the plug -arrow-.

GWWA15-10447Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

GWWA15-11390Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow-.

GWWA15-11401Courtesy of AUDI OF AMERICA, LLC

Two Different Chain Tensioners May Be Installed Depending on the Version: 

GWWA15-11397Courtesy of AUDI OF AMERICA, LLC

Version 1: 

-- Install the :T40243  -arrows-.

-- Lift up the locking wedge for the chain tensioner by inserting a scriber or a suitable screwdriver into the chain tensioner opening in direction of -arrow 1-. Slowly press and hold the :T40243  in direction of -arrow 2-.

TIP: 

The Chain Tensioner Is Lubricated With Oil And Can Only Be Pushed Back Slowly By Applying Constant Pressure.

-- Secure the chain tensioner using the :T40011  .

GWWA15-11398Courtesy of AUDI OF AMERICA, LLC

Version 2: 

GWWA15-11393Courtesy of AUDI OF AMERICA, LLC

-- Install the :T40243  -arrows-.

-- Press the chain tensioner circlip -1- together and hold it.

-- Slowly press and hold the :T40243  in direction of -arrow-. This will push back the chain tensioner.

TIP: 

The chain tensioner is lubricated with oil and can only be pushed back slowly by applying constant pressure.

-- Secure the chain tensioner with the :T40267  .

GWWA15-11394Courtesy of AUDI OF AMERICA, LLC

All Versions: 

-- Remove the :T40243  .