Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
- Replace the bolts that were tightened with an additional turn after removing them.
-- Mount the sub-assembly bracket and then install the bolts -4- first.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 5- | Install by hand all the way |
| 2. | -1 through 5- | 20 Nm |
| 3. | -1 through 5- | 90° additional turn |