LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> A5 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 643 (Body Front) >> 50 Body Front >> Bulkhead >> Plenum Chamber Cover, Removing And Installing

Plenum Chamber Cover, Removing And Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Note different versions.

Fig 1: Identifying Plenum Chamber Cover
GWWA50-10309Courtesy of AUDI OF AMERICA, LLC
  1. Cowl Panel Trim
    • The wiper arm is removed.
    • The left, center and right auxiliary covers are removed.
    • Remove the clamps -3-.
      NOTE:

      For easier removal/installation, spray windshield edge strip with soapy solution.

    • Pull the cowl panel straight off the frame starting from the window edge.
      CAUTION:

      Risk of window breaking during installation

      When installing, do not hit the cowl trim.

      Carefully press cowl trim in sideways, beginning in the frame.

  2. Plenum Chamber Cover
    • Remove the front clip first when removing.
    • Lift the front cover and remove it from the plenum chamber cover.
  3. Seal
    • Remove from the body flange toward the rear starting on the side.
  4. Plenum Chamber Bulkhead
  5. Windshield
  6. Frame
scientia non olet · About LEMON Manuals