Display And Control Head, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Installation is carried out in the reverse order while observing the following.

When replacing a Climatronic Control Module -J255- A/C display and control head, pay attention to the exact allocation. Refer to DISPLAY AND CONTROL HEAD LOCATION .

Mount the trim on the display and control head on the Audi Q5.

-- Clean the adhesive surface -D- on the display and control head -A-, for example, with cleaning solution D 009 401 04 .

Fig 1: Audi Q5 Climatronic Control Module Additional Trim Piece

Courtesy of AUDI OF AMERICA, LLC

-- Install the display and control head -A-.

NOTE:

The trim piece -B- is supplied with a two-sided adhesive strip already installed -C-

If the trim -B- is going to be re-used when replacing the display and control unit, the Climatronic Control Module -J255- -A- is also reused. Remove the adhesive strip -C- from the trim -B-. Clean the adhesive surface on the trim -B- as described in the instructions which came with the adhesive strip. Affix to the trim piece -B- a strip (dimension: 204 mm x 10 mm) of the two-sided adhesive tape -C- with material strength approximately 1.2 mm (for example with adhesive tape D 438 515 A1 ).

-- Mount the trim piece -B- with the adhesive tape -C- onto the adhesive surface -D- of the display and control head -A- and then align it -B-.

-- Press the trim piece -B- onto the surface -D-.

After replacing/installing the Climatronic Control Module -J255- A/C display and control head, always perform the follow work (refer to using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function):

-- Re-code (or check the coding) of the Climatronic Control Module -J255- A/C display and control head.

-- Perform the basic setting for the Climatronic Control Module -J255- A/C display and control head.

-- Check the DTC memory of the Climatronic Control Module -J255- A/C display and control head (correct the cause for any malfunctions displayed) and erase.

-- Check the adaptation of the Climatronic Control Module -J255- A/C display and control head and correct if necessary.

-- Perform the output diagnostic test mode for the Climatronic Control Module -J255- A/C display and control head (depending on the type of complaint).