Fresh Air Intake, Removing And Installing: Installing
Installation is done is reverse order, observe the following:
- Pay attention to the tightening sequence for the nuts -B- when installing them.
-- Tighten the nuts -B- lightly by hand in the following sequence.
- Tighten the inner lying nut -B- (at right in the illustration).
- Tighten the outer lying nut -B- (top left in the illustration).
- Tighten the outer lying nut -B- (bottom left in the illustration).
-- Tighten the nuts -B- according to the above tightening sequence (tightening specification: 3.5 Nm).
Check for damage prior to installing the fresh air intake -C- on the fresh air intake and the bonded seal; if there is damage, replace the seal or fresh air intake -C- .
When installing, make sure the fresh air intake -C- and seal are seated correctly; if the fresh air intake -C- is not installed correctly, water can seep into the A/C unit intake shroud through the sealing surface -D-.
Prior to installing the cowl cover -A- (there are different versions), check the cowl and the seals for the cover -A- and the window cross member -C- for damage; if the cover, the cowl or the seal are damaged, water can seep into the fresh air intake and also into the A/C intake shroud.