Outside Air Temperature Sensor -G17-, REMOVING AND INSTALLING: Notes
The measured value of the Outside Air Temperature Sensor -G17- is evaluated by the Vehicle Electrical System Control Module -J519- and is transmitted via the Data Bus to the Climatronic Control Module -J255- A/C display and control head (and the Instrument Cluster Control Module -J285-) using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function.
The illustration shows the allocation of the Outside Air Temperature Sensor -G17- -A- on the Audi A5 Coupe, the Audi A5 Sportback, the Audi A4, Audi Q5 etc. The allocation can vary.
If the vehicle has an Outside Air Temperature Sensor -G17- -A- with the bracket -B- installed on the air intake grille above the impact member, it is possible that a higher temperature may register due to the component location of the Outside Air Temperature Sensor -G17- under certain operating conditions (because the radiator and condenser are radiating heat, for example on MY 2008 vehicles). In MY 2009, the component location of the Outside Air Temperature Sensor -G17- -A- has been moved as a running change. The Outside Air Temperature Sensor -G17- with the new bracket -C- have been move slightly forward (closer to the radiator grille) and is under the impact member -D- .
If there is a complaint because the measured value is too high because the vehicle has the Outside Air Temperature Sensor -G17- -A- with the bracket -B- installed on the air intake grille above the impact member, then install an Outside Air Temperature Sensor -G17- -A- with the revised bracket -C- slightly forward (closer to the radiator grille) and under the impact member -D-. The wire connections may have to be lengthened . The bracket -C- is clipped into the impact member -D-. It may be necessary to drill a 7 mm hole into the impact member -D-.