Codes, Transmission Allocations, Ratios, Capacities (AUDI A4 From My 2008)
WARNING: This page is about a different variant/trim than selected.
| Rear Final Drive |
|
0BF |
| Codes |
|
LFU |
LFV |
LFW |
| Ratio |
Final drive Z2
: Z1 |
35 : 9 = 3.889 |
37 : 9 = 4.111 |
43 : 13 = 3.308 |
| Driveshaft flange diameter |
|
75.5 mm |
75.5 mm |
75.5 mm |
Gear oil - capacity
- For rear final drive (differential and pinion)
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
ATF capacity
- For the hydraulic control unit and chambers
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
| Rear Final Drive |
|
0BF |
| Codes |
|
LGH |
LGJ |
MBV |
| Ratio |
Final drive Z2
: Z1 |
37 : 10 = 3.700 |
35 : 8 = 4.375 |
35 : 9 = 3.889 |
| Driveshaft flange diameter |
|
75.5 mm |
75.5 mm |
75.5 mm |
Gear oil - capacity
- For rear final drive (differential and pinion)
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
ATF capacity
- For the hydraulic control unit and chambers
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
| Rear Final Drive |
|
0BF |
| Codes |
|
MBW |
MKU |
MKV |
| Ratio |
Final drive Z2
: Z1 |
37 : 10 = 3.700 |
37 : 9 = 4.111 |
43 : 13 = 3.308 |
| Driveshaft flange diameter |
|
75.5 mm |
75.5 mm |
75.5 mm |
Gear oil - capacity
- For rear final drive (differential and pinion)
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
ATF capacity
- For the hydraulic control unit and chambers
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
| Rear Final Drive |
|
0BF |
| Codes |
|
MKW |
MKX |
MKY |
| Ratio |
Final drive Z2
: Z1 |
35 : 8 = 4.375 |
35 : 9 = 3.889 |
37 : 10 = 3.700 |
| Driveshaft flange diameter |
|
75.5 mm |
75.5 mm |
75.5 mm |
Gear oil - capacity
- For rear final drive (differential and pinion)
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
ATF capacity
- For the hydraulic control unit and chambers
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |