ATF On Rear Final Drive 0BF And 0BE, Draining
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Drip Tray
Rear Final Drive 0BF
-- Remove the ATF check plug -arrow- so that the ATF drains faster.
-- Remove the ATF drain plug -arrow- and drain the ATF.
-- Install the new ATF drain plug -arrow- and tighten. Tightening specification, refer to -item 15- ATF Drain Plug (See Figure).
Rear Final Drive 0BE
-- Remove the ATF check plug -1- so that the ATF drains faster out of the drain hole.
-- Remove the ATF drain plug -2- and drain the ATF.
-- Install the new ATF drain plug -2- and tighten. Tightening specification, refer to -item 15- ATF Drain Plug (See Figure).
Continuation for All Rear Final Drives
-- Fill with ATF in the rear final drive. Refer to ATF ON REAR FINAL DRIVE 0BF AND 0BE, FILLING .