ATF Level In Rear Final Drive 0BF And 0BE, Checking

Test Requirement

• ATF temperature: 10 °C to 60 °C (50 °F to (140 °F)
• The rear final drive must be in the installed position.
• The vehicle must be level.

Special tools and workshop equipment required 

• Drip Tray

-- Remove the ATF check plug -1- to check the ATF level.

Fig 1: Locating ATF Plugs

Courtesy of AUDI OF AMERICA, LLC

• The ATF level is correct when the rear final drive is filled to the lower edge of the fill hole.

If the ATF is correct:

-- Install the new ATF check plug and fasten. Tightening specification, refer to -item  12- ATF Check Plug (See Figure).

If the ATF is not correct:

-- Fill with ATF. Refer to ATF ON REAR FINAL DRIVE 0BF AND 0BE, FILLING .