Overview - MECHATRONIC Circuit Boards
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- DSG Transmission Mechatronic -J743-
- Removing and installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Perform "Guided Functions " using the Vehicle Diagnostic Tester after replacing the DSG Transmission Mechatronic -J743-.
- Removing and installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Protector
- Cross-shaped
- Quantity: 2
- For Sub-Transmission 1 Valve 3 -N435- and Sub-Transmission 2 Valve 3 -N439-
- Install also in a transmission that does not have a protector
- Protector
- Rectangular
- Quantity: 4
- For the Sub-Transmission 1 Valve 4 -N436-, Sub-Transmission 2 Valve 4 -N440-, Cooling Oil Valve -N471-, Main Pressure Valve -N472-
- Install also in a transmission that does not have a protector
- Circuit Board 1
- Removing and installing. Refer to MECHATRONIC CIRCUIT BOARD, REMOVING AND INSTALLING .
- The contact springs on the circuit board can be connected one time only. A circuit board cannot be used again once it has been removed.
- Bolt
- Tightening specification and sequence. Refer to Fig 2
- Connector
- Circuit Board 2
- Removing and installing. Refer to MECHATRONIC CIRCUIT BOARD, REMOVING AND INSTALLING .
- The contact springs on the circuit board can be connected one time only. A circuit board cannot be used again once it has been removed.
- Bolt
- Tightening specification and sequence. Refer to Fig 3
- Connector
-- Tighten the bolts to 3 Nm in the following sequence: -1 to 5-.
-- Tighten the bolts to 3 Nm in the following sequence: -1 to 5-.