Brake Rotor, Removing And Installing, Brake Pads In Place: Installing

Clean the brake rotor, wheel hub and contact surfaces before installing.

-- Place the brake rotor on the hub.

NOTE:

When positioning the brake rotor, do not tilt it on the wheel hub.

-- Install the securing bolt -arrow- and tighten.

Fig 1: Identifying Brake Disc Secure Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake caliper with brake carrier. Refer to BRAKE CALIPER, REMOVING AND INSTALLING .

-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

NOTE:

Make sure the brake hose is correctly installed and secured inside the combination bracket on the stub axle carrier so that the brake hose does not come out of the bracket on its own.

-- Install the wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower vehicle.