LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> A4 2.0T >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Mechanical Components (Sedan) (As Of 01.2014) >> 46 Mechanical Components >> Front Brakes >> Brake Rotor, Removing And Installing >> Brake Rotor, Removing And Installing, 1LT And 1LY >> Installing

Brake Rotor, Removing And Installing, 1LT And 1LY: Installing

Clean the brake rotor, wheel hub and contact surfaces before installing.

-- Place the brake rotor on the hub.

NOTE:

When positioning the brake rotor, do not tilt it on the wheel hub.

-- Install the securing bolt -arrow- and tighten.

Fig 1: Identifying Brake Disc Secure Bolt
GWWA46-10018Courtesy of AUDI OF AMERICA, LLC

-- Install the brake caliper with the brake pads and front brake carrier. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, 1LT AND 1LY .

-- Install the wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

scientia non olet · About LEMON Manuals