LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> A4 2.0T >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Mechanical Components (Sedan) (As Of 01.2014) >> 46 Mechanical Components >> Front Brakes >> Brake Caliper, Replacing >> Brake Caliper, Replacing, 1LT And 1LY >> Removing

Brake Caliper, Replacing, 1LT And 1LY: Removing

-- Insert the Brake Pedal Actuator VAG 1869/2 between the brake pedal and driver seat by pressing the brake pedal down at least 60 mm.

Fig 1: Brake Pedal Depressor VAG 1869/2 Inserted Between Brake Pedal And Driver's Seat
GWWA44-0020Courtesy of AUDI OF AMERICA, LLC

-- Raise the vehicle.

-- Remove the wheels.

-- Connect the hose from a bleeder bottle to one of the bleeder screws on the front caliper.

-- Open a bleeder screw on the front brake caliper to reduce the pressure from the brake system.

-- Close the bleed screw and tighten to 13 Nm.

NOTE:

Do not remove the Brake Pedal Actuator VAG1869/2.

-- Remove the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, 1LT AND 1LY .

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.

The brake rotor is secured with a bolt.

-- Remove brake hose from brake caliper.

-- Remove the brake caliper from the vehicle.

-- Remove the bolts -5- on the brake carrier while holding the carrier securely.

Fig 2: Overview Of Front Brakes Components (1LT And 1LY)
GWWA46-10111Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake carrier.