Overview - Brake Pedal
WARNING:
The path of the brake pedal must not be shortened via extra floor mats.
- Lubricate all bearing and contact surfaces with Lubricating Grease G 000 450 02
- 1 -
Mounting Bracket for Pedal Assembly
- Illustration for vehicles with automatic transmission
- Removing and installing, vehicles with manual transmission. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION .
- Removing and installing. vehicles with automatic transmission. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING, VEHICLES WITH AUTOMATIC TRANSMISSION .
- 2 -
Sleeve
- 3 -
Brake Pedal Axle
- 4 -
Mounting Pin
- 5 -
Right Securing Clip (Spring Steel)
- 6 -
Washer
- 7 -
Gas Pedal Module Bolt
- 8 Nm
- 8 -
Accelerator Pedal Module
- 9 -
Pedal Support Bolt
- 20 Nm
- 10 -
Brake Lamp Sensor
- Removing and installing. Refer to BRAKE LAMP SENSOR, REMOVING AND INSTALLING .
- 11 -
Mounting Pin Bolt
- 8 Nm
- The bolt holds the mounting pins in position
- 12 -
Left Securing Clip (Spring Steel)
- 13 -
Brake Pedal
- Removing and Installing, with Manual Transmission. Refer to BRAKE PEDAL, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION .
- Removing and Installing, with Automatic Transmission. Refer to BRAKE PEDAL, REMOVING AND INSTALLING, VEHICLES WITH AUTOMATIC TRANSMISSION .WARNING:
If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.
- 14 -
Ball Socket Formed in Mount
- For the ball head on the brake booster push rod
- 15 -
Mount
- For the ball head on the brake booster push rod
- With ball stud retaining tabs
- Removing and installing. Refer to BRAKE BOOSTER PLUNGER MOUNT, REMOVING AND INSTALLING .
- 16 -
Nut
- 8 Nm
- 17 -
Stop
WARNING:If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.
- 18 -
Grommet
- Only installed on vehicles with automatic transmission