Wheel Alignment Measure Preparations
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Brake pedal actuator:V.A.G 1869/2
- Steering wheel level:VAS 6458
- Wheel alignment computer
The measurement sensor must be properly adjusted and attached to the vehicle; observe device manufacturer's operating instructions.
Make sure that the sliding plates and turn tables are not touching the end stop when checking the wheel alignment.
Drive the vehicle onto the alignment rack without tension. Move the vehicle back and forth if necessary to relieve any tension on the axle components.
The steering wheel must be "evened out" into the center position before beginning the measuring and adjusting. Use :VAS 6458 for this.