Active Steering Control Module -J792-, REMOVING AND INSTALLING: Installing: Notes

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disengage Carpet And Support It Using A Suitable Block Of Wood

Courtesy of AUDI OF AMERICA, LLC

Installation is the reverse of removal, with special attention to the following:

Follow the sequence when installing the control module:

-- Tighten the bracket -4- with the bolts -5- to the control module -8- to 8 Nm.

-- Connect the wiring harness connectors -3- to the control module -8-.

-- Carefully slide the wiring harness clip connection -3- into the bracket -4-.

-- Insert the control module with the bracket.

-- Connect the ground wire -2- to the threaded pin and tighten the nuts -1- to 6 Nm.

-- Tighten the nuts -7- to 6 Nm.

-- The system must be calibrated if the Active Steering Control Module -J792-. Refer to DYNAMIC STEERING BASIC SETTING .