LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.0L - Crankshaft & Cylinder Block - Engine Code(S): CCBA, CGXC & CTUB (Sedan) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt, Removing And Installing >> Supercharger Ribbed Belt, Removing And Installing >> Installing

Supercharger Ribbed Belt, Removing And Installing: Installing

Fig 1: Identifying Correct Belt Installation
GWWA13-10693Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Place the ribbed belt over the pulley as illustrated:

  1. Tensioner
  2. Supercharger
  3. Idler Roller
  4. Vibration damper
NOTE:

When installing the ribbed belt, make sure it is seated correctly on the pulleys.

-- Start the engine and check the belt routing.

-- Install the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals