Supercharger, Removing And Installing: Removing

Fig 1: Coolant Pipes

Courtesy of AUDI OF AMERICA, LLC

-- Remove the supercharger ribbed belt. Refer to SUPERCHARGER RIBBED BELT, REMOVING AND INSTALLING .

-- Place the Shop Crane - Drip Tray VAS6208 under engine.

-- Clamp off the coolant hoses with the Hose Clamps - Up To 25mm 3094 and remove them from the coolant pipes on the supercharger by loosening the hose clamps -1-.

NOTE:

The installation location is shown with the engine removed.

Ignore item -2-.

-- Free up the fuel hose -1- and the Evaporative Emission (EVAP) canister hose -2- on the air duct pipe.

Fig 2: Identifying Air Duct Pipe

Courtesy of AUDI OF AMERICA, LLC

-- Remove the vacuum hose -3- from the air guide pipe connection.

-- Remove the air guide pipe by loosening the hose clamp -4- and opening the clips -arrows-.

-- Press the release buttons to disconnect the connector -3- from the EVAP Canister Purge Regulator Valve 1 -N80- and to remove the vacuum hose -4-.

Fig 3: Removing EVAP Canister Purge Regulator Valve

Courtesy of AUDI OF AMERICA, LLC

-- Remove the EVAP Canister Purge Regulator Valve 1 -N80- from the bracket and lay it aside with the hose connected.

NOTE:

Ignore items -1 and 2-.

-- Disconnect the connector -arrow- from the Throttle Valve Control Module -J338-.

Fig 4: Identifying Connector -1- To Throttle Valve Control Module -J338-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -arrow- on the Control Valve Control Unit -J808-.

Fig 5: Identifying Connector -Arrow- To Control Valve Control Unit -J808-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1, 2 and 3-.

Fig 6: Installed Location: Secondary Air Injection Solenoid Valve And Intake Manifold Runner Control (IMRC) Valve -N316-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Mark the vacuum hoses for installation later.

-- Disconnect the vacuum hoses -4 through 7-.

-- Disconnect the connector -1- on the Intake Air Temperature Sensor -G42- / Manifold Absolute Pressure Sensor -G71-.

Fig 7: Identifying Connector -1- & Intake Air Temperature Sensor/Manifold Absolute Pressure Sensor Bolts

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore the -arrows-.

-- Disconnect the connector -3- (if equipped) and remove the vacuum hoses -1 and 2-.

Fig 8: Disconnecting Connector & Vacuum Hoses

Courtesy of AUDI OF AMERICA, LLC

-- Free up the vacuum hose -1-.

Fig 9: Identifying Vacuum Hose -1-, Bolts -Arrows- And Cover -2-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left and right bolts -arrows- and the cover and bracket -2-.

-- Free up the brake booster vacuum hose -2- on the bracket -1-.

Fig 10: Identifying Bracket -1- To Vacuum Hose

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1 and 2-.

Fig 11: Identifying Removal Of Nuts -Arrows- And Supercharger

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows- and remove the supercharger with the charge air coolers upward.

-- Seal off the openings on the supercharger and on the charge air pipe Engine Bung Set VAS6122.

-- Remove the noise insulation.