LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Mechanical Components (Sedan) (As Of 01.2014) >> 46 Mechanical Components >> Rear Brakes >> Brake Shield, Removing And Installing >> Installing

Brake Shield, Removing And Installing: Installing

-- Position the brake shield.

-- Install the bolts on the brake shield and tighten them.

-- Install the rear brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING, BRAKE PADS IN PLACE .

-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

NOTE:

Make sure the brake hose is correctly installed and secured inside the combination bracket on the stub axle carrier so that the brake hose does not come out of the bracket on its own.

-- Install the wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower vehicle.

scientia non olet · About LEMON Manuals