Overview - Center Differential Housing, Attached Driveshaft
NOTE:
Refer to REPAIR INFORMATION .
Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Bolt
- 20 Nm +90°
- Replacing
- Bolt
- Replacing
- Aluminum bolts
- Quantity 11
- Tightening specification and sequence. See Fig 2.
- Housing
- For the center differential
- Refer to CENTER DIFFERENTIAL HOUSING, REMOVING AND INSTALLING .
- Gear Carrier
- Installed position: The tab must fit into the opening in the transmission intermediate housing
- Center Differential
- Pressure Spring
- Assembly Sleeve
- Does not have to be installed again
- Locking Ring
- For the transmission output shaft ball bearing with splines
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Locking Ring
- For the transmission output shaft with splines
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Ball Bearing
- For the transmission output shaft with splines
- Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Bolt
- Replacing
- Steel bolts
- Quantity: 2
- Tightening specification and sequence. See Fig 2.
- Balance Weight
- Installed depending on the version
- Shaft Seal
- Replace on vehicles with vibration damper. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Replace on vehicles without vibration damper. Refer to TRANSMISSION OUTPUT SHAFT SEAL, REPLACING, TRANSMISSION OUTPUT SHAFT WITH SPLINES WITHOUT VIBRATION DAMPER .
- Dust Ring
- Replace after removing
- Transmission Output Shaft with Splines without Vibration Damper
- Allocate correct componets.
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Transmission Output Shaft with Splines and Vibration Damper
- Allocate correct componets.
- Removing and installing. Refer to TRANSMISSION OUTPUT SHAFT WITH SPLINES, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
-- Tighten the bolts in eight steps as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | Aluminum bolts -1- | 8 Nm |
| 2. | Aluminum bolts -2- | Install the bolt hand-tight. |
| 3. | Aluminum bolts -1- | Loosen again and then install all the way hand-tight |
| 4. | Aluminum bolts -3- | Install the bolt hand-tight. |
| 5. | Steel bolts -4- | Install the bolt hand-tight. |
| 6. | -1, 2, 3, 4- | 10 Nm diagonally |
| 7. | Steel bolts -4- | 15 Nm |
| 8. | -1, 2, 3, 4- | 90° additional turn, diagonally |