LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Passenger Protection, Airbags, Seat Belts (Sedan) >> 69 Passenger Protection, Airbags, Seat Belts >> Seat Belts >> Rear Seat Belt Guide, Removing And Installing >> Outer Rear Belt Guide, Removing And Installing, AVANT >> Removing

Outer Rear Belt Guide, Removing And Installing, AVANT: Removing

Fig 1: Lifting Spring Latch And Sliding Belt Guide Back Out Of Bracket
GWWA69-10023Courtesy of AUDI OF AMERICA, LLC
CAUTION:
  • When removing and installing the belt guide, do not remove the bolts installed in the belt guide from below. They are set by the manufacturer.
  • Replace the entire belt guide if damaged.

-- Remove the luggage compartment side trim. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING, AVANT .

-- Remove the foam piece from the opening under the belt guide -1-.

-- Insert a screwdriver into the opening under the belt guide and press the clip upward -arrow A- and hold it.

-- Push the belt guide to the rear -arrow B- until the bolt heads can be disengaged from the bracket on the body.

-- Rear outer right seat belt guide: Disconnect the connector from the Rear Parking Aid Warning Buzzer -H15-.