Rear Flange Shaft Seal, Removing And Installing

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Remove the center differential housing -B-. Refer to CENTER DIFFERENTIAL HOUSING, REMOVING AND INSTALLING .

Fig 1: Locating Center Differential Housing Bolts

Courtesy of AUDI OF AMERICA, LLC

Remove the circlip -arrow-.

Fig 2: Identifying Circlip

Courtesy of AUDI OF AMERICA, LLC

Removing the flange shaft.

Fig 3: Pressing Out Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Place the center differential housing so that the flange shaft does not contact the Press Plates VW401 and VW402 when pressing it on.

NOTE:

Disregard item -2-.

Pry out the shaft seal -1-.

Fig 4: Prying Out Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

Installing Shaft Seal

Fig 5: Cardan Flange T40165 Seal Installer

Courtesy of AUDI OF AMERICA, LLC

Lightly coat the shaft seal on the outer circumference with oil and then install it until it stops. Do not bend the seal.

-- Fill the space between the sealing and dust lip halfway with Sealing Grease G 052 128 A1.

Install the flange shaft.

Fig 6: Identifying Tool Set Up For Shaft Installation

Courtesy of AUDI OF AMERICA, LLC

The flange shaft ball bearing in installed.
The Press Piece - Press Tube 30-100 presses on the inner race of the ball bearing when pressing in.

-- Mount the flange shaft seal -arrow-.

Fig 7: Identifying Circlip

Courtesy of AUDI OF AMERICA, LLC

-- Install the center differential and the center differential housing. Refer to INSTALLING .