Input Shaft Seal, Replacing, AUDI A5 Coupe, From My 2008 Through Transmission Series Number 000760
WARNING: This page is about a different variant/trim than selected.
NOTE:
Transmission with these transmissions series numbers were installed only in the Audi A5 Coupe from MY 2008.
Special tools and workshop equipment required
- Puller - Crankshaft/Power Steering Seal T20143/1
- Seal Installer - Crankshaft T10122
- Seal Installer - Input Shaft Oil Seal T10184
- Sealing Grease G 052 128 A1
- Transmission removed. Refer to TRANSMISSION, REMOVING AND INSTALLING .
-- Remove the clutch module. Refer to CLUTCH MODULE, REMOVING AND INSTALLING .
-- Pry out the input shaft seal.
-- Lightly coat the outer circumference of the new shaft seal with oil.
-- Fill the space between the sealing and dust lip halfway with Sealing Grease G 052 128 A1.
-- Drive the new seal in until it is flush without tilting it.
-- Install the clutch module. Refer to CLUTCH MODULE, REMOVING AND INSTALLING. .