Input Shaft Seal, Replacing, AUDI A4 And AUDI A5 Coupe, From My 2008, From Transmission Series Number 000761

Special tools and workshop equipment required 

• Puller - Crankshaft/Power Steering Seal T20143/1
• Seal Installer - Shaft Seal T40174
• Sealing Grease G 052 128 A1

• Transmission removed. Refer to TRANSMISSION, REMOVING AND INSTALLING .

-- Remove the clutch module. Refer to CLUTCH MODULE, REMOVING AND INSTALLING .

-- Pry out the input shaft seal.

Fig 1: Removing Input Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Lightly coat the outer circumference of the new shaft seal with oil.

Fig 2: Installing Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing and dust lip halfway with Sealing Grease G 052 128 A1.

-- Install the shaft seal all the way. Be careful not to bend it.

-- Install the clutch module. Refer to CLUTCH MODULE, REMOVING AND INSTALLING .