LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Controls & Housing - Manual Transmission Internal Components 0B4 (Sedan)) >> 34 Controls, Housing >> Transmission Housing And Clutch Housing >> Overview - Transmission Housing

Overview - Transmission Housing

WARNING: This page is about a different variant/trim than selected.
NOTE:

It is not possible to disassemble and assemble the differential.

Removing and installing the pinion is currently not possible.

Adjusting the pinion and the ring gear is currently not possible.

Replacement: replace the transmission housing together with the installed pinion and differential.

Fig 1: Identifying Transmission Housing Components
GWWA34-10828Courtesy of AUDI OF AMERICA, LLC
  1. Intermediate Piece
    • Replace if damaged
  2. Ball Stud
    • 25 Nm
    • Bearing surface on clutch release lever with Grease for Clutch Disc Shaft Splines G 000 100
  3. Shaft Seal
  4. Differential
    • Can currently be replaced only with the transmission housing and the pinion
      NOTE:

      The differential bevel gears cannot be removed or installed.

  5. O-Ring
    • Always replace.
    • Coat with transmission fluid
  6. Final Drive Cover
  7. Bolt
    • 24 Nm
    • Steel bolts (M8; 42 mm long)
    • Quantity 10
  8. Right Flange Shaft
  9. Shaft Seal
  10. Bearing Bushing
    • For the gearshift rail / shift fork
    • Quantity: 2
    • Removing. Refer to Figure.
    • Installing. Refer to Figure.
  11. Pinion
    • Can currently be replaced only with the transmission housing and the differential
  12. Plate
    • to lock the ball bearing in the transmission housing on
    • Installation position: The recesses for the bolts face the transmission cover
  13. Bolt
    • 24 Nm
    • Insert with Locking Fluid AMV 185 101 A1
  14. Ball Bearing
    • For the output shaft
    • bearing height is 19 mm
    • Do not swap out with a ball bearing; refer to -item  15- Ball Bearing
    • Removing. Refer to Figure
    • Installing. Refer to Figure
  15. Ball Bearing
    • For the input shaft
    • Bearing height is 17 mm
    • Do not swap out with a ball bearing; refer to -item  14- Ball Bearing
    • Removing. Refer to Figure
    • Installing. Refer to Figure
  16. Drain Plug
    • 40 Nm
  17. Transmission Housing
    • Can currently be replaced only with the differential and the pinion
scientia non olet · About LEMON Manuals