LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Controls & Housing - Manual Transmission Internal Components 0B4 (Sedan)) >> 34 Controls, Housing >> Securing On Engine And Transmission Holder

Securing On Engine And Transmission Holder

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required 

Procedure

Fig 1: Securing T40206 To Transmission
GWWA34-10727Courtesy of AUDI OF AMERICA, LLC
CAUTION:

There is a risk of breaking the transmission housing.

  • The transmission must be attached with the four bolts -arrows- and the Transmission Holder, otherwise when the gear set is pressed out the transmission housing can break.

-- Attach the Gearbox Support T40206 using the Template Gearbox Support - Drilling T40206/3 to the transmission -arrows-.

-- Lift the transmission using the Shop Crane VAS6100. Refer to TRANSMISSION, TRANSPORTING .

Fig 2: Lifting Transmission With Shop Crane VAS6100
GWWA37-11038Courtesy of AUDI OF AMERICA, LLC

-- Place the transmission on the Engine And Transmission Holder VAS6095 with the Gearbox Support T40206

scientia non olet · About LEMON Manuals