Transmission Tightening Specifications: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
The tightening specifications apply only to lightly greased, oiled, phosphated or blackened nuts and bolts.
Additional lubricants, such as engine oil or transmission fluid are permissible, but lubricants containing graphite are not.
Do not use any ungreased parts.
Tightening specification tolerance ± 15%.
| Component | Nm | ||
|---|---|---|---|
| Bolts and nuts | M6 | 9 | |
| M7 | 15 | ||
| M8 | 20 | ||
| M10 | 40 | ||
| M12 | 65 | ||
| except for the following: | |||