Transmission Range Gear Recognition Switch -F208-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

-- Install the Transmission Range Gear Recognition Switch -F208- in the selector shaft cover. Tightening specification. Refer to TIGHTENING SPECIFICATION .

NOTE:

Ignore items -1- and -3-.

Fig 1: Attaching Bolts And For Selector Rod And Push Rod

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -arrows- on the tunnel crossmember. Tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT -item 2- Bolt (See Figure).

Fig 2: Identifying Bolts & Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

-- Assemble the exhaust system making sure it is not under stress. Refer to OVERVIEW - MUFFLER , and EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .

-- Install the rear noise insulation. Refer to OVERVIEW - NOISE INSULATION .