Overview - Selector Mechanism
WARNING: This page is about a different variant/trim than selected.
- Circlip
- remove ball when removing
- Spacer
- Pressure Spring
- Ball Guide
- Do not lubricate
- Ball
- Do not lubricate
- Insulation
- For the shift lever support, refer to -item 11- Shift Lever Support.
- Do not lubricate
- Bolt
- 23 Nm
- Clamping Plate
- Do not lubricate
- Gearshift Lever
- Offset faces toward rear
- Lubricate the tip-pressure guide and shift lever stops.
- Grease the contact surfaces for the joint; refer to -item 12- Joint Piece .
- Spacer Tube
- Grease the outer circumference .
- Shift Lever Support
- Removing and installing. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .
- Do not lubricate
- Joint Piece
- Between the selector rod and shift lever
- Grease the contact surfaces for the shift lever .
- Bolt
- For the joint piece, refer to -item 12.
- Bolt
- 23 Nm
- Nut
- 10 Nm
- Gearshift Rod
- Push Rod
- With screw and washers
- Nut
- 20 Nm
- Always replace.
- Bolt
- 4 Nm
- Gearshift LeverCAUTION:
Danger of causing damage to the gearshift shaft inside the transmission.
- Do not pry the transmission shift lever off using a pry bar or hit it with a hammer.
- Use only the Puller - Gear Shaft Linkage T40160 to pull the transmission shift lever off.
- Removing. Refer to Fig 2
- Insert so that master spline aligns with shift rod
- Sealing Boot
- Ball Socket
- Grease the bearing area for the transmission shift lever. Refer to -item 20- Gearshift Lever. Grease as needed.
- Bearing Bushing
- Connecting Rod
- To remove, remove the clip, refer to -item 26- Clip.
- Bolt
- 20 Nm
- Clip
- Bolt
- 20 Nm
CAUTION:
Danger of causing damage to the gearshift shaft inside the transmission.
- Do not pry off the transmission shift lever -1- using a pry bar or hit it with a hammer.
- Use only the Puller - Gear Shaft Linkage T40160 to pull the transmission shift lever off.
-- Position the Puller - Gear Shaft Linkage T40160 and remove the gearshift lever -1-.