Gear Recognition Sensor -G604-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
-- Replace the O-rings -4-.
CAUTION:
There is a risk of breaking or causing malfunctions in the Gear Recognition Sensor -G604- during installation.
- The Gear Recognition Sensor -G604- -3- may not be banged or bolted -1- into the transmission.
- The O-rings -4- and the opening in the transmission cover must be lubricated with transmission fluid.
- The Gear Recognition Sensor -G604- -3- may be lightly pressed on with an aid, for example a hammer shaft.
-- Secure the Gear Recognition Sensor -G604- with the bolt -1-. Tightening specification. Refer to Tightening Specification .
-- Connect the connector -1- and lock if necessary.
-- Tighten the bolts -arrows- on the tunnel crossmember. Tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT -item 2- Bolt (See Figure).
-- Assemble the exhaust system making sure it is not under stress. Refer to OVERVIEW - MUFFLER , and EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .