Clutch Pedal, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
-- Lubricate all bearing areas and contact surfaces with Lubricating Grease G 000 450 02.
-- Install the clutch pedal -3- and install the bearing axle -1- and lock it in direction of -arrow A-. The securing tab -2- must engage on the bottom of the pedal bracket.
-- Install the mounting pins -4-. The shoulder on the pin -arrow B- must be guided into the groove in the clutch pedal.
-- Install the over-center spring. Refer to INSTALLING THE OVER-CENTER SPRING .
-- Install the mounting bracket. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING .