Left Upper Timing Chain Cover, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the old sealant from the sealing surfaces on the timing chain cover.

CAUTION:

Risk of contaminating the lubricating system.

Cover open parts of engine.

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Remove any remaining sealant on the timing chain cover -1- and cylinder head using, for example, a rotating plastic brush.

Courtesy of AUDI OF AMERICA, LLC

-- Clean any oil or grease off the sealing surfaces.

NOTE:

Pay attention to the expiration date of the sealant.

-- Cut the tube nozzle at the front marking (nozzle diameter: about 1.5 mm).

Courtesy of AUDI OF AMERICA, LLC

-- Install the seal -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Apply a small amount of sealant to the transitions between the cylinder head and the lower timing chain cover -arrow- as shown in the illustration.

CAUTION:

The lubrication system could be plugged with excess sealant.

Do not apply sealant bead thicker than indicated.

The sealant bead must be 1.5 to 2.0 mm above the sealing surface.

-- Apply sealant beads -1 and 2- to the clean sealing surface of the left timing chain cover as shown in the illustration.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The timing chain covers must be installed within 5 minutes after applying the sealant.

-- Position the timing chain cover and tighten the bolts. .

Installation is performed in reverse order of removal, while noting the following:

-- Install the left cylinder head cover. Refer to CYLINDER HEAD COVER LEFT AND RIGHT, INSTALLING AND REMOVING, VEHICLES WITH A TURBOCHARGER .

-- Install the particulate filter.