Overview - Timing Chain Cover: Notes

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Timing Chain Cover

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Tightening specification and sequence. Refer to OVERVIEW - TIMING CHAIN COVER .
- Always replace
Sensor Wheel
- For the Engine Speed Sensor -G28-
Shaft Seal
- For the crankshaft on the transmission side
- Removing and Installing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
Lower Timing Chain Cover
- Removing and Installing. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
Alignment Sleeve
Seal
- Always replace
Bolt
- Tightening specification and sequence. Refer to Tightening Specifications .
- Always replace
Left Timing Chain Cover
- Removing and Installing. Refer to LEFT UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence. Refer to Tightening Specifications .
- Always replace
Seal
- Always replace
Bolt
- Tightening specification and sequence. Tightening Specifications .
- Always replace
Right Timing Chain Cover
- Removing and Installing. Refer to TIMING CHAIN GUARD UPPER SECTION, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence. Refer to Tightening Specifications .
- Always replace
Alignment Sleeve
Sealing Piece
- Quantity: 2
Engine Speed Sensor -G28-
- Removing and Installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
Bolt
- Tightening specification -item 8- OVERVIEW - GLOW PLUG SYSTEM