Catalytic Converter, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When Installing, Bring All Cable Ties Back To Same Positions.
-- Remove the front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .
-- Remove the nut -2- from below.
NOTE:
The nuts -1- will be removed later.
-- Disconnect the connector -1- on the Oxygen Sensor after Three Way Catalytic Converter -G130- -2- and free up the wire.
-- Remove the nut -1- from above and remove the catalytic converter from above.