LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 989 (Engine Assembly- CYNB) >> Engine Assembly >> Assembly Mounts >> Transmission Mount, Removing And Installing >> Transmission Mount, Removing And Installing, Manual Transmission >> Installing

Transmission Mount, Removing And Installing, Manual Transmission: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the transmission support -3- on the transmission mount -5- and tighten the nut -4- hand tight.

-- Tighten the lower stop -2- with the bolts -1-.

-- Tighten the nut -4-.

-- Install the transmission support with the transmission mount. Refer to TRANSMISSION SUPPORT WITH TRANSMISSION MOUNT, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals