Pistons, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following:

NOTE:

Replace The Bolts That Were Tightened With An Additional Turn.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston and piston ring compressor.

Installation Position:

Piston. Refer to INSTALLED POSITION OF PISTON AND PISTON/CYLINDER ALLOCATION .
Connecting rod. Refer to CONNECTING ROD, INSTALLED LOCATION .

-- Install the connecting rod bearing cap according to the marking.

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Install the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .