LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 988 (Crankshaft, Cylinder Block- CREC, Cred, CREH) >> Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Drive Plate, Removing And Installing >> Installing

Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following: 

NOTE:

Replace The Bolts That Were Tightened With An Additional Turn.

-- Be careful of the alignment bushings during installation.

-- Reposition the :10-201  to tighten the bolts.

scientia non olet · About LEMON Manuals