Battery Cooling Module, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition.
-- Discharge the refrigerant circuit. Refer to REFRIGERANT CIRCUIT [For engine(s) CTUA, CAED, CREH, CEUC, CTGE, CREC, CYNB, CPNB] .
-- Remove the inlet air guide for the traction battery. Refer to Traction Battery -A2- INLET AIR GUIDE, REMOVING AND INSTALLING .
-- Remove the bolt -2- and disconnect the refrigerant line -1-.
-- Remove the bolt -3- and remove the refrigerant line -4-.
-- Seal the open lines and connections with clean plugs from the Engine Bung Set :VAS6122 .
-- Disconnect and free up the connectors -1, 2 and 3-.
-- Remove the nuts -arrows- and remove the battery cooling module.