Traction Battery -A2- INLET AIR GUIDE, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition.
-- Remove the luggage compartment floor covering. Refer to LUGGAGE COMPARTMENT TRIM PANELS .
-- Remove the rear outlet air guide for the traction battery. Refer to Traction Battery -A2- REAR OUTLET AIR GUIDE, REMOVING AND INSTALLING .
-- Remove the front outlet air guide for the traction battery. Refer to Traction Battery -A2- FRONT OUTLET AIR GUIDE, REMOVING AND INSTALLING .
-- Remove the bolts -2, 4 and 6- on the left and right side, if applicable.
-- Release the retaining tabs -1- and remove the inlet air guide -3- from the battery cooling module.
-- Carefully unclip the inlet air guide -7- from the retainers -arrows- on the air guides -5- and remove it.