Right Vent Temperature Sensor -G151-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Installation is done is reverse order, observe the following:
-- Replace the seal -2- if it is damaged or faulty.
After completing the repair work, perform the following operations on the control head using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function:
-- Check the Diagnostic Trouble Code (DTC) memory and delete any currently displayed entries.