LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 982 (Supercharger System (Service Information - CREC, CREH)) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Pressure Sensor - G31- / -G447-, Removing And Installing >> Installing

Charge Air Pressure Sensor - G31- / -G447-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

NOTE:

Replace the self-locking screws and O-ring after removal.

Clean the threaded holes for the charge air pressure sensor inside the supercharger housing with a thread tap before assembling.

-- Install the supercharger. Refer to SUPERCHARGER, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals