LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 979 (Engine Cooling System (Service Information - CYNB - 1 Of 2)) >> 19 Cooling System >> Coolant Pump/Thermostat >> Coolant Pump, Removing And Installing >> Installing

Coolant Pump, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Additional Procedures: 

-- Connect the coolant hose to the connector coupling. Refer to Figure.

-- Install The Throttle Valve Control Module -J338-. Refer to THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING [CYMC, CYRB, CYRC, CWPB, DAXB, DAXC, CJEB, CJED, CJEE, CNCD, CNCE, CUHA, CUJA, CNCB, CUHB, DAYB, CYGA, CYNB, CYPA, CYPB, CYYA, CVJA ENGINES] and/or THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING [CYNB] .

scientia non olet · About LEMON Manuals