Tightening Specifications

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Refer to OVERVIEW - CONDENSER, VEHICLES WITH HIGH-VOLTAGE SYSTEM

-- Replace the O-ring seals depending on the version. Refer to the Parts information.

-- If applicable, inspect the alignment pin -4- for damage and check that it is seated correctly.

-- Inspect the guide ring -2- on the refrigerant line connection for damage.

-- Insert the O-ring seal -3- into the groove -arrow- on the refrigerant line connection -1-.

NOTE:

Coat O-rings with refrigerant oil before installing. Refer to REFRIGERANT CIRCUIT SEALS .

Check O-ring seals for proper seating in groove -arrow- of respective refrigerant line.

Following attachment, check routing of refrigerant lines. They must be inserted in holders provided and not make contact with other components.

-- Insert the refrigerant lines in the respective connections on the condenser.

-- Tighten the bolts.

-- Evacuating and recharging refrigerant circuit. Refer to appropriate service information .

-- Operate the A/C system after charging the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

NOTE:

Read the information for starting the A/C system after installing the A/C compressor. Refer to appropriate service information .

-- Check the Diagnostic Trouble Code (DTC) memory and erase any displayed entries using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.