Refrigerant Lines, Disconnecting And Connecting At Condenser: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- For vehicles with a high-voltage system (Audi A6 e-tron), switch off (deactivate) the "parking air conditioner" function. Refer to the Owner's Manual and Infotainment/MMI Operating Manual.

-- Discharge the refrigerant circuit. Refer to appropriate service information. .

-- Remove the lock carrier cover. Refer to FRONT BUMPER .

Audi RS 6/RS 7

-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

Continuation for All

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and disconnect the refrigerant line -1-.

-- Seal the open lines and connections with clean plugs from the Engine Bung Set:VAS6122 .

-- Remove the bumper cover end plate. Refer to FRONT BUMPER .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and remove the refrigerant line -2-.

-- Seal the open lines and connections with clean plugs from the Engine Bung Set:VAS6122 .