Refrigerant Lines To Receiver/Dryer, Disconnecting From Condenser: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- For vehicles with a high-voltage system (Audi A6 e-tron), switch off (deactivate) the "parking air conditioner" function. Refer to the Owner's Manual and Infotainment/MMI Operating Manual.

-- Switch off the ignition.

-- Discharge the refrigerant circuit. Refer to appropriate service information. .

-- Remove the impact member. Refer to IMPACT MEMBER, REMOVING AND INSTALLING .

WARNING:

Danger due to refrigerant coming out under pressure.

Danger of frost bite to skin and other parts of the body.

Evacuate the refrigerant and immediately open the refrigerant circuit afterward.
If more than 10 minutes have elapsed since evacuating the refrigerant and the refrigerant circuit was not opened, evacuate the refrigerant again. Pressure in the refrigerant circuit is caused by evaporation.

-- Remove the nut -A- (tightening specification: 9 Nm) and remove the refrigerant lines to the receiver/dryer -B and C- from the condenser -F-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Seal the open line connections at the connection point and the condenser with clean plugs, for example from the :VAS6122 .