Refrigerant Lines To Receiver/Dryer, Disconnecting From Condenser: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following.

NOTE:

Follow the instructions for installing the O-rings. Refer to REFRIGERANT CIRCUIT SEALS .

Following attachment, check routing of refrigerant lines. They must be inserted in brackets provided and not make contact with other components.

-- Replace the O-rings -D and E-. Refer to the Parts information for the version.

-- Evacuate and fill the refrigerant circuit. Refer to appropriate service information. .

-- Install the remaining removed components.

-- Switch the ignition on.

-- Check and, if necessary, erase any displayed faults in the DTC memory for the Climatronic Control Module -J255- control head and the Thermal Management Control Module -J1024- using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

-- Operate the A/C system after charging the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

NOTE:

Note the information regarding operating the A/C system after filling. .