LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 977 (Climate Control System (Service Information - (Refrigerant Circuit) CAEB, CGXB, CEUC, CTUA, CEUC, CAED, CHJA, CPNB, CRDB, CPNB, CREC, CTGE, CYNB, CWUC, CREH, CWUB)) >> Air Conditioning >> Refrigerant Circuit >> Receiver/Dryer, Removing And Installing >> Receiver/Dryer, Removing And Installing At Condenser (Not For AUDI A6 E-Tron) >> Tightening Specifications

Tightening Specifications

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Pull the protective boot -A- over the connection.

-- Evacuate and fill the refrigerant circuit. Refer to appropriate service information .

-- Operate the A/C system after charging the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

NOTE:

Read the information for starting the A/C system after installing the A/C compressor. .

-- Check the DTC memory and erase any displayed entries using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

scientia non olet · About LEMON Manuals