Vehicle Diagnosis, Closing And Sending The Diagnostic Log

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Perform the test programs according to the test plan.

-- Switch to the control modules tab.

-- Press the X Diagnosis button and end the diagnosis.

-- Send the diagnostic log online.

NOTE:

Deleting the DTC memory takes place when exiting the Guided Fault Finding,

Sending the diagnostic log takes place when exiting the Guided Fault Finding,

If there is no network connection available, the diagnostic log is temporarily saved a few days. The online transfer should then take place as soon as possible.