Fuel Pressure Sensor -G247-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
NOTE:
The Fuel Pressure Sensor -G247- does not have gasket. It has a biting edge and for this reason cannot be reused.
Check the new Fuel Pressure Sensor -G247- for damage to biting edge and thread.
Check the sealing surface on the hole inside the high pressure reservoir.
Coat the Fuel Pressure Sensor -G247- thread and biting edge with diesel fuel.
-- Tighten the Fuel Pressure Sensor -G247- by hand.
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Check the fuel system for leaks. Refer to FUEL SYSTEM LEAK TEST .